Menu Close

Music Operated Dancing LED Project

0 0
Read Time:2 Minute, 0 Second

Music Operated Dancing LED’s Using BC547 Transistor

Theory Overview:
  • You must have seen the Disco Lights or DJ lights, which Turn ON and OFF according to the beats of the music. These lights glow according to the length and pitch (volume) of music beats, basically these are designed to pick the high intensity sound like Bass sound. So these lights follow the high pitch beats in music like drum beats, and Turn ON and OFF according to music pattern.
  • However the sensitivity of the circuit can be increased to pick the low notes too . Previously we have built Dancing LEDs, which just follow a set pattern and we can only control the speed.
  • Now we are taking this to next level, i.e. Music Operated Dancing LEDs, in which LEDs will flash according to music, just like Disco light, as discussed above. This Musical LEDs circuit is based on transistor BC547. This circuit is very simple and easy to build, it just requires few basic components and it looks very cool.
Components Required:
  1. Capacitor 100nF(Ceramic)
  2. Resistors: [ 10K ohm (2) , 1k  ohm (4), 1M ohm (1) ]
  3. NPN-Transistor BC547  (5)
  4. MIC (Condensor)
  5. LED’s    (4)
  6. 9v Battery plus holder
  7. Connecting wires
  8. Bread Board Or PCB Sheet

Circuit Diagram:

Explanation / Working:
  • In this Simple LED Music Light Circuit, condenser mic picks up the sound signals and converts them into voltage levels. These voltage signals are further fed into R-C filter or HIGH PASS filter(R2 and C1), to eliminate the noise from the sound. Further a NPN transistor (Q1- BC547) is used to amplify the signals, from the High Pass filter.
  • Then finally these music signals are given to the array of four transistors. Transistor in this array works as amplifier, and glows the four LEDs according to the sound pattern. This generates a very interesting sequence of dancing LEDs which follows the beats as per their intensity or pitch. We can also add more LEDs with transistor to make it cooler.
Transistor BC547:

NPN transistor, which is used as a Amplifier here. NPN transistor acts as a open switch when there is no voltage applied on its Base (B) and it acts as closed switch when these is some voltage at its base. Generally 0.7 volt is enough to get it fully conducted.

Project Construction Video:
Happy
Happy
0 %
Sad
Sad
0 %
Excited
Excited
0 %
Sleepy
Sleepy
0 %
Angry
Angry
0 %
Surprise
Surprise
0 %

Related Posts

Average Rating

5 Star
0%
4 Star
0%
3 Star
0%
2 Star
0%
1 Star
0%

Leave a Reply

Your email address will not be published.

%d bloggers like this: